How to operate the floor washing machine

1. Garbage cleaning

Clean the epoxy floor once, especially the large-scale garbage, which will affect the cleaning effect, and it needs to be cleaned in time.

2. Inject clean water

According to the cleaning area, the right amount of clean water should be injected into the cleaning tank of the washing machine, and appropriate amount of industrial low foam detergent should be added according to the degree of oil contamination on the ground.

3. Turn on the switch

Put down the brush disc, turn on the key, open the brush disc and water absorption switch, and adjust the water volume properly.

4. Uniform cleaning

At this time, the floor washer can be pushed to clean the epoxy floor at a constant speed.

5. Close switch

After the work is completed, turn off the brush disc switch, lift it up, turn off the water absorption switch, and then turn off the key switch.

6. Flush with water

Push the washing machine to a safe place, discharge the sewage, clear water and wash.

7. Dry and place

Dry the floor washer and place it in a dry and ventilated place.

Performance and cost of electric floor washer

I. performance characteristics

1. Electric operation, no noise and exhaust emission;

2. The cleaning effect is good, and the ground that has been dried by washing and brushing is free of residual water trace.

3. Small size, flexible turning, easy to drive, convenient maintenance, suitable for most manual cleaning places;

Dirty water, soil and sand are all sucked into the waste water tank, especially for the oily ground. After the machine is cleaned, it is as clean as new, which is not as good as manual work.

II. Economic analysis of use cost

1. The cleaning efficiency is high. The driving washing machine can wash and dry more than 6000 square meters per hour. It can replace 20 manual mopping. The hand washing machine can wash and dry 2 thousand square meters per hour instead of 12 people.

2. The use cost is low, only 3-6 yuan of electricity is needed every day, vulnerable parts are cheap, and they are replaced three times a year.