How to solve the common problems of washing machine

I. question: can't the water absorption motor of the washing machine start?

A: 1. Check whether the water volume of the sewage tank is full. 2. Check whether the water level sensor in the sewage tank is blocked by foreign matters or fails.

2. Question: what's left on the ground?

A: 1. Check whether the water absorption rubber strip is worn. 2. Check whether there is any foreign matter between the two suction rakes. 3. Check the suction pipe for foreign matters. 4. Check whether the suction filter is damaged or not clean. 5. Check whether the sealing ring of the sewage tank cover is in good condition. 6. Check whether the suction pipe is correctly connected to the suction grill.

3. Question: is the operation time of the machine short?

A: 1. A fully charged machine can operate for 3.5 to 4 hours. 2. Charge for at least 8 hours. 3. When it cannot operate for 1.5 hours after being fully charged, please contact the after-sales Center for solution.

IV. what is the poor water absorption function of the floor washing machine?

A: 1. The cover of the sewage tank is locked. 2. The cover of sewage drainage pipe is locked. 3. Check and make sure that the suction pipe of the suction grill is clean and not blocked. 4. Check and confirm that the adhesive strip is true and has contact with the floor. 5. If the rubber strip is not sharp enough, please use its sharp edge at the outer end.

5. Question: is there any stain left on the ground?

Answer: check whether the brush / cleaning pad is used to clean the floor and stains.

Vi. question: water stains left on the ground?

Answer: 1. Whether the cleaned ground belongs to soft ground. 2. Check whether there is any foreign matter between the two suction rakes. 3. Check whether the water absorption rubber strip is worn. 4. Check whether the suction grill is adjusted correctly.

7. Question: is there a watermark in the cleaned place?

A: 1. Wipe the dirt on the rubber strip with a cloth. 2. Check and confirm that the edge of the adhesive strip is sharp and has not changed.

8. Can't the charger be used?

A: 1. Connect the charger to the battery connector. 2. Plug the charger into the power supply. 3. The pointer of ammeter shall move and the charging lamp shall flash. 4. If the above instructions are invalid, please contact the after-sales center.

9. Ask: does the washing machine not come out of water?

Answer: 1. Check and confirm that the water size regulating lever key has been turned on. 2. Check and confirm that there is water in the clean water tank. 3. Check and confirm that the clean water filter screen is clean.

10. Can't the brush turn?

A: check that the brush master switch is on.